"This code does not belong to your account"
You are opening another license’s kiosk link, or you are not signed in with the account that owns the license. Always use the URL from your own Configurator, Hardware tab.
The link opened on the wrong device
It paired with the first device that opened it. In the Hardware tab, press Unlink and open the link on the right device. If someone else may have seen it, use Regenerate.
"Connection lost" when the kiosk starts
The kiosk did not hear from the controller in time. Check that the controller is powered, paired and on the same local network as the FAP computer, then press Reconnect. On a slow network, raise the initial connection timeout. To practice without hardware, press Continue offline.
The controller shows as disconnected
Check the controller’s power and internet connection. Open its logs: if there are no recent pings, restart it. Also check that it has not been revoked.
Commands do not reach the hardware
Enable Debug logs and repeat the action. If the event appears in the logs, the problem is the wiring or the controller pin; if it does not, it is communication between the FAP and the controller: check that both are on the same router.
The kiosk does not show my changes
Press Save configuration and hard-refresh the kiosk: the computer’s browser may keep the previous version in cache.
There is no sound in the kiosk
Tap Start on the start screen: browsers require that first gesture to enable audio. If you disabled the start overlay, tap anywhere on the screen.