The Hardware add-on extends your FAP Trainer license to connect the trainer to a physical cabin. Without it, the FAP works fully on screen; with it, the FAP reads your switches and drives real lights and mechanisms.
The two pieces
- Screen controller: the browser on the computer that shows the FAP in kiosk mode. It is paired by opening the Screen controller URL.
- Controller: a board (Arduino or compatible) wired to your hardware, with inputs for switches such as seat belts or doors, outputs for LEDs and annunciators, PWM outputs for cabin lights and commands for accessories such as smoke machines. It is paired with the token it shows at start-up.
What it adds in practice
The physical seat belts switch changes the FAP state instantly, emergency lights and annunciators light up on your panel, doors with sensors show on Doors/Slides, and the FAP or the instructor station can trigger the smoke machines, the electrical failure or the oxygen masks.
Network requirements
The controller and the screen controller computer must be on the same local network (the same router). The controller also needs internet access to validate the license and send its pings. Pairing each piece is explained in the next two articles.