Hardware: Controller

The Controller card in the Hardware tab manages the board that connects the FAP to your physical cabin.

Pairing the controller

Power on the controller: at start-up it shows a token on its screen or Serial port. Type it or paste it with Paste into the Token field and press Link. The device name updates automatically when it sends its first ping.

Once paired you will see its status (active, pending or revoked), last contact, IP address and firmware version. Removing the pairing revokes the device: it stops working and you will need to pair a new one.

Communication settings

  • Long-poll timeout: how long, in milliseconds, the controller keeps a waiting request open. Default 30000 (range 5000–120000). Leave it as is for normal use.
  • Offline threshold: if the controller does not ping within this time, in seconds, it is considered disconnected. Default 300. If it shows as disconnected on a good connection, check its internet access before changing this value.

Pulses, blinks and lights

  • Oxygen mask pulse: time, in milliseconds, the solenoid stays active. Keep it short so the mechanism is not strained.
  • Blink rates for smoke detection, CABIN PRESS and emergency call, in milliseconds.
  • Cabin lights: BRT, DIM 1 and DIM 2 intensity as a percentage (0–100), which the controller converts to PWM for your LED strips, and the transition speed between levels.

Controller logs

At the bottom of the card you will see the latest events received, with date, IP and content, and you can open the full history with date filters. It is the first diagnostic tool when something does not respond.